The unthinkable just happend

Wow
What the hell ??????

 

Oh man, sorry to hear. You won't know the root cause of how it went until you get in there... damaged belt, pulley fence/sprocket bearing, tensioner bearing... What did you have them replace in the course of work? One thing I've learned in situations like this is that sometimes timing of a failure post-work is coincidental, sometimes it is not, and it is always best to stay level headed and objective.

Best of luck, and keep us posted.

 

Very sorry to hear. But your mechanic's heart will sink to the floor when he gets your message. His reputation is at stake. His mind will start racing trying to think of any possibility as to how it happened.

Will likely be at a loss until he can put his eyes & hands on the car and be able to identify the reason for your issue. There have been a number of parts failures in the industry as of late. I have personally run into a rash of incorrectly part numbered grills. I have over $1,000 in wrong grills from Ferrari in my office. Both packages had the correct number, but the wrong part came out. One from Ricambi and the other from Ferrari, directly.

Please remain calm and allow your trusted mechanic to figure this out. He will take this every bit as personally as you do!

 

Sorry to hear of your misfortune. You say you threw it in neutral - was the car still running or did you have to endure the sound of your valves being crunched? Just wondering if there's any chance it could be an accessory belt rather than timing. Crossing fingers for a good outcome for you!

 

Oh boy. Sorry to hear

Keep us updated.

 

Sorry to hear about your car.

This is why I have NEVER used an independent Ferrari mechanic. When I have work done on my cars, I only go to a Ferrari dealership with Ferrari parts, I get a two year warranty on all work performed.

I'm ready to be flamed.

 

Good grief....do Ferrari dealerships use non-humans to do the work?

 

Flame #1.

The two dealerships that have worked on my six Ferraris have awesome people in the service departments. As long as I use factory Ferrari parts I get a two year warranty on all work performed.

It is all about the Dealership standing by their work. Bad things can happen at a Ferrari Dealership. Losses caused by replacement part failure, or technicians mistakes will be covered. The service department has to take a hit that is absorbed as a loss in that months profit / loss.

 

Wow, sorry to hear man.

I am also curious to know what happened here.

 

That's not a flame, that was a question.

Do you want me to tell you my experience at a Ferrari Dealership?

 

Did you get any photos when you took the inspection plate off?just curious

 

Retrace you route and look for the belt.

 

Probably forgot to tighten a bolt on a bearing or tensioner. This is easily done and has the same result when they back out. All it takes is an interuption during reassembly.


Hope it gets work out soon. Let us know the diagnosis

 

Seriously? The belt is gone??? Wowzer.

Images of bent valves running through my head. 348 has one belt for both banks correct? Ouch.

Hope that shop is insured.

 

People are human, mistakes happen. Investigate properly and see what the shop does to remedy this. The judgement should come from how they handle the situation.

 

Wow. That sucks. Hope they stand behind the work and make it right.

 

Very sorry to here. Hopefully the mechanic will rectify the situation asap no questions asked.

 

Yup, it's possible. Failure to fully tighten a cam cog or tensioner can cause it to cock and the belt to track off or up against a fence. That's why they got that fancy yellow paint.

 

This is the first time I read of this. Sorry to hear and hope your mechanic will do the right thing!