© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I have a picture of it from 2014 and it was silver then.
Nope - I haven't installed them. They were on Ivan's list, so I presumed they were a real replacement. In any event, they're cheap enough that...
Another option might be the Stabilus/Sachs/LiftoMat SG130006 listed in Ivan's Bora parts interchange. I bought a pair and they look right, but I...
Thanks for posting this. Here's a small aside to complement Ferriripilot's comment: I took it out for a water pump replacement, so there are a...
The VR1 spec says 5.2W maximum, during alarm and this converter claims 8W capability, so if you go that way it should be OK. The VR1 apparently...
Mine had Bosch fog lights, but unfortunately I no longer have the car, so I can't help with the questions. I never used them and can't even be...
The Bora is US974, a 1977 car.
Doesn't it also say "si" on the servo sterzo (power steering) line?
Beautiful - I wish mine looked that good!
Gearvendors makes a couple for the 727, part numbers Part # 3DFS727A and # 3DFS731A.
I've never modified mine, but at one point I was looking into making a conversion to a manual transmission. I tried to find the original...
It seems that the Sanden 6" pulley has enough material to be re-machined with Polyflex 60 degree grooves.
Not a Bora, but the same structure. This happened last month in Dallas. I removed the picture of the owner. He wasn't hurt, but he looked pretty...
The unusual two bumps on each side of the rear bumper could be plugs for the mounting holes of the rubber bumperettes added to the '73 and '74 US...
Maybe these will shed some light on the "US" question. In one case the author says explicitly that he copied the numbers from the US distributor...
564 is another common number. A couple of years ago I also wondered about this line in the book, so I did a casual web search for my own...
I think that's an air-oil separator for crankcase ventilation. That would be a typical modification for an engine that is expected to run at high...
You can still get a 508 for R12, but R12 is now very expensive. There are substitutes - I used Freeze 12 in my old pickup and got cold air,...
Several companies make brackets to adapt the Sanden 508 rotary compressor to the York bolt pattern. Here's...