© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
32 front 30 rear
stock tire sizes 235/35 20 F 295/35 20 R
Anybody have experience with Yokohama Neova tires on the track? Had some on my 458 and felt little "sloppy"; like not stiff enough side walls....
I installed the Forza controller; that is all I need! Gives great options for what sound you want.
I just finished installing on my coupe. The Forza "tip sheet" is helpful. I removed the air box enough to get aacces to the wiring below. Meant...
i have done the change to Giro, and it went well. They are much heavier. I needed to zip-tie the brake wear wires back as the new pads had no...
I have 15mm front and 20mm rear, with novitec. Was some rubbing when I "slammed" it at first, but I adjusted it up until it was fine. Front and...
Love the carbon fiber in the engine bay. Nice build!
I am no brake expert, but is it possible that some pressure is kept in the rear brake system causing the brakes to be partially engaged? That is,...
I love your seats! I agree with the yellow calipers; but is great as is!
Front and rears were just barely under the weight limit. I have been in race mode on track, CT on. I guess I will chang that. I will probably...
So I take my car into the Ferrari dealership for a pre-track inspection (for the dealership's sponsored event). My car is a 2012, with 15k miles....
I bled mine using a maxisys elite tool with a battery maintainer on the car, real pain. But all said and done I am not so sure I needed to do...
i will dig out my numbers on the wheel offsets and check fender height i was rubbing on the rear portion of the liner when turning sharp i did...
what size front tires you using? i went to 245/30 which stopped my rubbing. if you get a chance i would be curious what the fender height is...
I also have the 21" and 22' wheels. My car must be set up higher, as I have only had rubbing when the wheel is fully turned (on rear part of...
Anyone have advice on best way to bleed the front lift system on 458? I installed lowering springs and in removing the assembly some fluid is...
I am looking at getting some Brixton wheels for my 458. Anyone have any info on their quality?