© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I echo all the previous comments and have been here. I have Victor Reinze gaskets and they seem fine. My concern however is, how do you know the...
Ive had very similar experiences in the past - I'm with Tony; go for the carbs. however I would take off the problem one (actually easier to do...
here are some more pics when it was on the test bed [ATTACH] [ATTACH]
from a ford v6 coil pack tucked behind the oil/ water heat exchanger, then routed through the caps of the distributor and to the plugs so it all...
yes I have been there - the trigger wheel just clamps on the crank pulley and for the rest I used standard ford bits and a few brackets. a...
I have been on the edge of doing this for a while - would love to know exactly what the gains are - please share with lots of photos! Nick
I had mine to pieces a couple of years ago. the output shafts tighten up when the diff is under load from the engine. until then they flop around...
seeing all of those fantastic garages has made me realise that I need to upgrade! The next project awaits its slot. [ATTACH]
I think it also helps to keep the tank topped up; circulating a small volume of fuel doesn't help.
a great guy; I have pestered him many times and he always had time and patience for an amateur. Hope he has a terrific retirement. so who do we...
many thanks for the suggestions - will report back when I have solved it. it the mean time I have done a fabulous bodge of welding the cable back...
the flexble drive that goes from the wiper motor to the wiper on the right hand side of my car is snapped. I am drawing a blank as to where to...
I feel the same way - sounds like a beer might be on the cards!
English male. so this begs the question; are there any female members? I suspect they are all to busy doing something more useful! Nick
I agree with Tony; this is not a friendly site - a heady mix of men, money, egos and cars!
I had a similar problem and I traced it to the engine mounts - its easy to get them the wrong way round and cant the engine at an angle
It turns out my machinist makes working model engines in his spare time - aero radial, merlin, etc. and a selection of motor bike engines. I was...
yes thats the one from superformance. it is heavy round town and manoeuvring but fab elsewhere; really sharp.
I used these guys - Radford Panel,classic car body panels as you say everything needs fettling to get it to fit but overall everything was ok...
its probably common knowledge but I found a volvo garage that was throwing out shims from 740 and 940 models that appear to be identical to the...