© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
The two boards work quite well, i don't plan any design changes, but since i don't have time supporting and building then nowadays unfortunately i...
Not sure how that post fits into this thread to be honest :)
Hella came back and basically denied the issue, but their description of what they tested and how they did the evaluation made clear that they did...
I haven't tried this yet but a compatible replacement could be the magnetic pickup for the Fiat 124 Spider which is readily available as a spare....
I measured different Pertronix MR trigger setups on the test bench a while ago and noticed that they all had several degrees of timing variance...
Those currents are a bit on the low side, looks like you need to check and adjust the sensor gaps.
You refer to the Type 2/3 board? I did but due to the different design from Marelli it is not really a DIY replacement anymore. It would need...
You could try heat up the brass case with a heat gun to around 200º, then you should be able to push out the epoxy including the board by applying...
Looks good!
Hi Brian, for creating the ground connection you can either directly sold one of the ground pads to the enclosure at the thread side of the body...
The distance can be 0mm (flush), but it should not extend outside of the brass enclosure as the air gap is quite small.
Given the small volume and minimal thermal expansion i would not expect any issues. I am using PU for such applications though which stays a bit...
Barry, looks like the needle slipped. Have posted a reply in the thread you listed.
Pretty sure the needle socket/axle connection slipped if the ODO/trip are still fine. Open the speedo (remove front bezel and rear three screws),...
I could do a custom board for displaying 1/2 the pulses to get the right speed. Not sure that an aftermarket speed reducer will work since the...
In the meantime, here is another tested and qualified module for this setup. It is a Marelli license build made in Turkey: MAKO www.mako.com.tr...
Merry Christmas! Hella Service Aftermarket came back, they will validate the reported defect in the next weeks based on stock modules and then...
@Furryballer You can't get any useful results with the multimeter in resistance mode on the amplifier unfortunately, it is an integrated circuit...
Ok, thanks for the test, so your modules are also affected. I don't understand the part about the "tester across the amplifier", how did you test...
@Furryballer i've reported this to Hella product mgmt, hope to get some response this week. It would be quite helpful if you can test your setup...