© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I bought the 5000SXL which is 5000lb capacity rated. There is a locking bar at 2 different heights. They are heavier than they look.
I strongly believe I can. I would need to lift it,Put jack stand in and add the extension that I bought for SUV's. I can comfortably work...
My little lift[ATTACH][ATTACH] Sent from my SM-G955U using Tapatalk
Love it! Cant wait to try out myself. Sent from my SM-G955U using Tapatalk
200-250 miles. Is usually when i fill up. I never trust the gauge completely. Sometimes makes huge swings from half to empty Sent from my...
If it is debris derived, I have had 1 in 1 million things like this happen to a variety of cars, last one was a small rock some how getting stuck...
Doug, did you bite on the the car?
Congratulations Geoff!
I bought mine from BHCC. I do believe that they "flip cars" (sounds harsh), but they appear to be cars that the previous owner had a hard time...
Just to close this out, bought the slave cylinder at AW Italian. I considered the rebuild and still may rebuild the one I took off. Anyhow, I...
Thank you.
Any vendor recommendations for replacement cloth braided hose? Most of my lines are starting to look pretty bad. TIA, Donnie
Stefan, saw your post with Goldfinger thread. I will definitely check out when i replace the slave cylinder. Thanks. Sent from my SM-G955U...
I am interested Stefan. Sent from my SM-G955U using Tapatalk
Well after writing this. I went back to look and poke around some more. I pressed the push rod upward and low and behold squirting liquid. So is...
Back by latch seems to be tucked under a trim peice and srewed in. Other pic is from side [ATTACH][ATTACH] Sent from my SM-G955U using Tapatalk
Guys, after getting to finally finish my CV boot/drive axle repair, Cranked up the car to let it warm up while I cleared up the lift and some...
Aaron, you are correct. It is and I have been using a 2.5 diameter dowel rod and mallet to get into a "more" round shape. As someone commented...
So far. It is alot heavier than I thought it would be. But it seems to work well and set up was pretty easy. Have you checked out YouTube...
I have not tried. I did get the extentions with plans to do so in future. I think i have to lift it up and put it on jack stands, then add the...