© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks for your help
Now you are just being a jerk. Please stop bothering me with your nonsense. I appreciate you ignoring my posts.
So you feel it necessary to qualify my experience level before answering a question? How about just pass on answering at all? It's nice that...
After I put the engine in and drove the car, I had problems with shifting into all gears. I removed exhaust on drivers side to get access to a...
I just completed the 30,000 miles engine out maintenance. Since I could not find a call out on torque, I wanted to make sure I installed...
I am installing my exhaust manifold to the engine block. Does anyone know the torque value of the 13 mm brass nut that goes on the stud? I cannot...
Thank you Steve. Just completed a 30K engine out service. Took the car for a short drive. No Reverse and was not sure what gears I was in with my...
I know this is an older post but can anyone tell me where in the WSM is this link adjustment procedure? Thank you
Thanks for the reply. It looks like my car does not have a emergency hood release for the engine compartment. I have attached photos of the inside...
The cable is under the speaker panel. I removed the cover and there it was. Thanks to everyone for the help in locating. I have one more question...
I see the emergency release cable in my owners manual but do not see it in the car. Could it be behind the speaker cover?
Today I closed the luggage compartment hood on my 86 TR. It stuck and I could not open it. I pulled on the release and snapped the cable, shown in...
I rebuilt the Master Cylinder on my 86 TR. I am trying to bench bleed the Master Cylinder by connecting a short hose to front and the rear and...
Yes. That's it. I finally got it off. Pry very slowly and it finally popped off. Thanks
EDoug Thanks for all the detail. I really appreciate it.
So can you tell me how? I cannot find the discussion in the 328 forum.
Are you talking about the one that says use a slide hammer with a bearing puller adapter?
I kind of mis spoke. It is not the clip. It is the cap or push nut on the shaft. Photo shows it on shaft. Not sure what it is called. But it needs...
I am attaching a photo of a clip on the end of the Master Cylinder from my 1986 Testarossa. I am trying to pry it off so I can get to the rubber...
I have a 1986 Testarossa. I would like to pack the front wheel bearings. Does anyone know where the procedure for removing the bearing and packing...