© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
A short video of the issue would say more than a thousand words. Sent fra min SM-G935F via Tapatalk
Yes it can. I did. Sent fra min SM-G935F via Tapatalk
My 348 did a similar thing a couple of years ago when I bought it.I had one of the banks shut down a split second at idle, but couldn't tell which...
Thanks. I'll have to try them on first. Tires are completely wrong, but at least I'll be able to see how the rim fits. Sent fra min SM-G935F via...
I've just bought a set of F430 wheels. Needs machining at the rear (10" ET 39 rims) to fit the 348. Needs at least to be ET 50 if it's not going...
If I remember correctly you need the nipple on top. Sent from my SM-G935F using FerrariChat.com mobile app
Not helping you guys, but believe it or not, in Norway the 348 is actually cheaper to insure than a Prius. I pay under $300 USD fully insured...
M8 x 1mm Sent fra min SM-G935F via Tapatalk
It runs at 500 -600 rpm. Then it suddenly wakes up and revs at 1500 rpm in a snap, and everything is normal. The fault doesn't last long enough to...
Rpm is shown on dial. No warning lights are abnormal. Both banks turn off their check lights at the same time... Sent fra min SM-G935F via Tapatalk
Hi guys! I have a intermediate problem with one of the banks not starting for several seconds when cold. Could be as much as 5-6 second. I have no...
Hi,Thanks! I only need the pipe size inner and outer diameter. Sent fra min SM-G935F via Tapatalk
Hi! Does anyone have the exact measurement on the inner and outer diameter of the outlet on the exhaust manifold? Or does anyone have one laying...
Good to know. I have a slow start on one of the banks. It could be a relay. Sent fra min SM-G935F via Tapatalk
The easiest way is to sell the 348 and buy a 355... If you destroy the 348 you'll loose $$. The same amount of money for trading the 348 to a...
Same happened to me. Opened up the MAF sensor cover and it was water inside... Sent fra min SM-G935F via Tapatalk
The heater circuit is measured with a ohm meter. The ohm meter itself outputs 9 volt. The Ecu outputs 12 volt on this circuit, so that circuit is...
I agree. I had a O2 sensor issues recently myself, and after heating and measuring it I was able to get it working again. But anyway I ordered new...
I find it more interesting to find the problem than just replacing parts. Sent fra min SM-G935F via Tapatalk
The heater circuit should be 5 to 10 ohms. The sebsor circuit should be measured in volt when operating. 0.00 volt when exposed to oxygen and...