© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
@patina Thank you. What an experience.
I have enjoyed the 360 for some years and I am on to my next project. I am reaching out to those that liked the car to tell that the car will be...
I’m selling the car on bringatrailer in the next couple of weeks. I’m off to my next adventure.
Sold
Sorry Fabspeed, I stand corrected. I should have never posted anything negative unless I see it myself. And they seem to have concerns about their...
[ATTACH]
Sorry, only repeating what a member with a long history on eBay. If you would like i’ll send him your contact information. I’ll PM you as to not...
It is a tough crowd. ;) I can remember drooling on similar headers years ago at $3,500.
Thanks, i’ll look into that.
Being these headers i’m selling are tube fabrication, they will pull into place. It’s not like a cast iron manifold. But the Fabspeed are way out....
Fabspeed ”Expensive and Junk”?
They are 4 into one.
Seems wrong, to me, that one would need to surface the interface that meets the head. It’s not like it became out of plane during shipment....
Update on the gentleman who had problems with a set of headers during installation. The Indy Ferrari tech said he would not try to tighten them...
I measured the flange to cylinder head surface on the header and was pleased it is straight. The two middle flanges have a very small gap on both...
I was in contact with a guy who had a problem fitting them. He said flanges are are not uniform or in plane. I looked at that when I purchased and...
I have not tried installing them. The flanges are flat and Dimensions between the ports and stud holes are consistent. Hard to believe, at least...
I would imagine these will sounds a little louder and be able to discern a bit of the individual exhaust pulses over the hug factory headers.
I never installed them, they are brand new never installed. I am selling and going to purchase something newer.
I was very impressed with their heat rejection numbers.