© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Gentlemen: I am sorry I have been absent from this discussion for some weeks! I finally received the crankshaft position sensors and the cam shaft...
Yes, each connector goes to the respective ECU. I noticed that the diagram shoes two conductors and the plugs have three. Do you think the third...
There is a plug each side behind the rear shock absorber. [ATTACH] [ATTACH]
Just as a review: My car has one fuel pump, one cam sensor (situated on the right bank, the crank sensor for the left bank is kaput, there is no...
I found the connectors that interconnect the cam phase signals to each ECU. Continuity is intact. The cam sensor is receiving 12V. I think the...
I will check continuity from the cam sensor to the ECU later today.
I have given this some more thought and it seems to me that a mechanic I used to work with disconnected one of the CPS in order to insure the...
It is apparent that the crankshaft position sensor (CSP) for the LH (5-8) is faulty as there is no internal resistance and no AC voltage when the...
Great! Thank-you. Just had delivery of camshaft sensor and am waiting for two crank sensors.
I am back at it and am waiting for delivery of two crank sensors and a cam sensor though I am not convinced that this is the problem. Can anyone...
Good point but the camshaft phase sensor is the same for the 5.2 and 2.7. Also you can check if the belt has skipped a few teeth by finding TDC,...
Before I departed for my country house I did check if there was power to the cam sensor with light and it shone brightly. I did not check the...
I believe the source voltage for the cashft sensor is 12 volts? Please advise.
Could a multimeter be used in place of the LED?
Thanks for the info. I will check this and your other valuable suggestions when I get back.
Excuse my ignorance, but what is the meaning of the ZN - 0.5/2 label on, for example, the wire connected to the LH crank sensor. I know the ZN...
Your help is much appreciated. By zooming in with Paint I can now see the colours of the wires and their routing. With your explanation can now go...
Thanks. I have a PC and Paint allows me to zoom in.Now that I can see the detail around the pump relay, (relay P), I am not clear how the relay is...
Thanks for the print. Unfortunately, It is very difficult to read. My computer won't allow me to enlarge it. I have made some progress and see...
Thanks for the explanation. The induction type sensors normally have two wires. What is the 3rd wire on the cs sensor for? I know it it is a...