© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Have you considered having the painting scanned and having a limited run printed using the giclee process? I would like a copy of the original...
You cannot just add the memory switch. The memory seat has a completely different wiring harness, ECU, and position sensors on each of the motors....
Welcome to Ferrari ownership. Ferrari made many running changes to parts that are not currently reflected in the online catalogues or catalogues...
The Lucas relays are easy to rebuild. I remove the external can and send it out for plating and then polish the contacts with 1000/1200/2500 grit...
See this thread: https://www.ferrarichat.com/forum/threads/tr-water-pump-seal.563354/ and this information:...
The original hose is made from EPDM rubber. That is what you should be looking for to replace it. Fuel/oil hoses are made from buna-n rubber,...
Aluminum has only 60% of the thermal conductivity of copper. In order for an aluminum radiator to have the same efficiency of the same size copper...
Most dealer techs don't recognize the clicking noise as a problem, and/or don't know what causes it or what the repair involves. They are trying...
Don't worry about driving the car with the clicking condition. You are not going to hurt/damage the car. If you ignored the problem for a very...
It sounds like one or both of the rear axles are loose in the hubs. Have someone stand on either side of the car to listen to see if the click is...
Drive belts don't just "melt" on their own. Something seized and caused the belt to self destruct. I suggest further investigation to determine...
One of the top position sensors has most likely gone bad. If the top ECU does not know the position of all of the components, it will stop working...
Ughh, reading all of the back and forth from the techs that know what they are doing (Rifledriver, tbakowsky, etc) and what the OP is doing with...
Unless the alignment shop you use specializes in exotics/vintage Ferraris, they are probably not going to have the correct factory Ferrari type...
I'm with Dyke on the fuel pressure as well. If it still works, I set the Fispa pressure regulator to 3.5PSI. I recommend getting the lowest...
I was out taking 0387GT/0139E for it's first test drive since installing the motor that Patrick Ottis rebuilt a few years ago. Still doing a...
You can clean up the flywheel with a small piece of Scotchbrite pad clamped in some long hemostats through the timing inspection hole. Have...
You have to measure the resistance of the valve coil windings at the ABS control unit electrical connector
Ed, looking at the fuse panel straight on: The large black plastic CEAM relay provides power with the ignition key on to the four upper fuses on...