© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Out of curiosity, and since I’m looking for them too, I found the ones that I replaced a few years ago and measured them. It looks like roughly...
I purchased my front and rear sets from Superformance UK. If you have a press, various sockets and an angle grinder you can do it relatively...
Hi, I’m looking for advice on an indoor car cover for my 348TS. Would like one that is form fitting and well tailored. I’ve searched the site and...
You’ll need everything Yelcab mentioned above. As for the specialty ring nut tool, you’ll be better off buying one rather than making your own, in...
Nice fix. Sent from my iPhone using FerrariChat
I too have the Nouvalari Super Sport with Fabspeed test pipes and it does indeed scream. This is not the setup you’d want if you’re looking for...
Leave the MAF screens in place, and throw in the K&N if you wish. The computer will figure it out over time. It’s a small factor. Once you start...
I just fixed my headliner. If you have any questions about it, PM me. Sent from my iPhone using FerrariChat
As a matter of fact i had new speakers put in about 3 years ago. I have the originals and I’ll check to see if the connector fits. Thanks for the...
For comparison this is off my ‘94 348 Serie Speciale. There seems to be a few differences. [ATTACH] Sent from my iPhone using FerrariChat.com...
Sorry about that. It’s a 1994 348. It’s a 2 spade connector and has a purple wire and a doubled up green. Sent from my iPhone using FerrariChat
I pulled the gauge cluster to check connections and found this connector tucked away. I didn’t see anything obvious for it to connect to. I...
I believe those are the ones I got. Sent from my iPhone using FerrariChat.com mobile app
I picked up a set off eBay. I wanted to see what the quality would be like. They were roughly $40 for the pair and far exceeded my expectations....
I did the major on my 348 over the winter and had mine welded. I feel better about not having to worry about if it could become an issue....
I have the same issue with panel gaps from the hood to the fender. I don’t see it as much of an issue, and plan to remedy it at some point. As for...
Its not necessarily the belt you should be worried about. It’s everything else, ie. bearings, pulley fences, tensioner pads, seals, that need...
I’ve seen similar cables used to secure and lock a car cover. It goes from one side of the car cover to the other underneath the car. Sent...
Did you check for codes yet? Sent from my iPhone using FerrariChat
Also have the Nouvolari, but with Fabspeed bypass pipes. It’s loud and it smells, but I love it. Sent from my iPhone using FerrariChat