© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I need to tap into the FC Brain Trust. I have the following issue: My ’86 USA 328 is stock with the exception it has no cats. There is a new OS...
Issues resolved. I've gone ahead and ordered all new vacuum hoses. A project I'll tackle in the future.
Thanks for all your replies. It turned out to be the vacuum supply for the air injection system. I was able to find the connecting hose hiding...
You are correct in that the WUR connects to the throttle body. That connection is "before" the butterfly (and I have that connection on my car)....
On my '86 328 throttle body there is a 1" long pipe extending downwards from the bottom of the body. What is its purpose? Is there supposed to...
Thanks Steve, you confirmed my suspicions. My 328 surges at idle when warm and set to 1K rpms. At 1200, it's fine. I think my next step is to...
I have a US 328 with a straight pipe replacing the catalytic converter. I have the O2 sensor mounted in the straight pipe, but the Thermocouple...
Steve, thank you. It would appear that whoever rebuilt the trans drove the bore tubes flush with the bottom of the trans case and consequently,...
I am helping a friend align the shifter on a newly rebuilt 308 GTSI transmission and have run into some major problems. The major issue is...
It seems the problem is in the WUR. I measured and then SIGHTLY tapped down the control rod a fraction of an inch (bronze "cap" located on the...
When I let the '86 USA 328 sit for a few weeks, the engine floods when starting. It will only run on a few cylinders. It is not cylinder bank...
Do you recall if there are any holes in the lid under the hinges to facilitate removing the rear spoiler?
Does anyone have a picture of a removed engine lid (side view showing hinge mounting area)? thanks,Paul
Let us know if you are going to market them.
I had the same issue as stated above. The problem turned out to be a burnt connection in the plastic connector located on the left side of the...
If possible, remove the gas from the tanks outside. I know of a shop in NJ that burned to the ground because the "mechanic" was draining old gas...
Your car is 30 years old. I would strongly suggest you consider replacing ALL the fuel related hoses including the filler neck and vapor hoses....
Any available?
After using a timing wheel with the engine out, I came up with the same results as you currently have. FWIW. To obtain better results, you will...
To answer your question: If you took it to a reputable restoration shop, around $125,000 give or take 10% when the crying is done.