© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Realize the post says US spec car but curious there are no rear side maker lights.
I'm a little curious about the 10% rule. Does this apply to both modern and vintage cars? The reason I ask is because in the Roush Daytona book...
This is a long shot, but what you describe happened on my son's older Infinity. The issue was the "rheostat", and that's probably a bad word for...
For the past several years I have always done what Redneck does. Take the wheels off, even if I have to do one side at a time. and take them...
I had mine rebuilt by the Koni factory in KY and was pleased. One was rusted through and they had to remake with an outside tube. The paint...
I own both and have for quite some time. Both have renewed suspensions and new tires. I think the Boxer drives much better than the Daytona....
Mine broke at the very same spot on the Daytona. I always open the hood before and during warmup to check. ...and carry a fire extinguisher.
Automatic Seafood Wife suggested it Sent from my iPhone using Tapatalk
Highlands Bar and Grill El Barrio But they feed you pretty well at the Grand Bohemian It’s a great school and time Beautiful grounds Sent...
Sorry Dyke, Looks like I misread your recommendation and bought the wrong plugs. Thanks to you and Edward for straightening me out.
Fair question Edward. The BPR6EIX is the plug that came up the most as a replacement when I was searching for a replacement and Dyke R mentioned...
Its time to replace the plugs in my Daytona. I had always used NGK BP6ES with a 0.5 - 0.6mm (about 0.020 to 0.025 inches) gap with good results....
Thanks Andrew. Somehow missed that in the posts. I enjoyed reading the F40 section of your web site, Drew
Sorry to be a "Johnny come lately" to this thread. But could not find the information I was looking for in any of the posts. Does the price...
I'm running NGK BP6ES as Edward showed above in my Euro Daytona. I also have a set of NGK BPR6EIX which is the Iridium equivalent I believe but...
You might have to bleed the clutch master cylinder again if what Steve suggested does not work out.
I've done this before. Just don't bend the wire sufficiently to break it lose from the vent. Slide the wire under one edge. Get a popsicle...
R12 Romano
I think you know this, but you should pull a vacuum on the system first then charge. When I did the engine out on my Boxer I charged until there...
Don't you need 6" of concrete depth to use a two post lift safely. Most garage slabs are closer to 4" which is fine for a 4 post.
