© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
It's mine, i'm needing the money, no kdding. Check out all my links, thanks for looking!
I made some longer pins and used smaller washers so I could easily remove them and rotate the cam (by inserting the pin in the next closest hole)....
Oreily's, stuff with steel wool, may need to remove and repack one every 1.5 years
Rent a coolant system pressure tester from Advance Auto. Screw it into the res and pump it up.
See pic. Correct. Incorrect. I never said steel. I believe they are a bronze steel mix, many debates about the desired makeup of...
I was talking about the seats. For the guides, use a big hand drill. A small one will stall out half way through. Seats = hand turn with the...
I spun by hand until I got consistent cuts, then used the lapping compounds with a drill motor attached via a rubber hose to stem. My goal was to...
One's a 31 and 46, the other is a 60. Part numbers from cylinderheadsupplies is 103 seat cutter and 111 seat cutter. I learned a lot by...
Easy as cake with the 6mm guide driver, hooked to an air chisel at about 80 psi. Place head in oven, set on 250 degrees for 1.5 hours, remove and...
My local 355 friend pointed me to sivalves.com. I got both the valves and guides from them. 1100 for the set of valves and around 12.50 each for...
Good question, and I don't know the answer. I checked for intake and exhaust leaks and didn't find any (still have factory manifolds installed at...
I had the same issue and found a purposely installed obstruction (round plastic piece with a pin hole in it) where the fuel return line connects...
Thanks to all your advice, plus the local guidance from an fchatr who I know his name but not his user id, and some words of wisdom through...
cuz you didn't say 'yes' to 'show all content' hello!
Sorry, I meant to say 'I bet you're *not* answering yes'...
I bet you're answering yes to 'show all content' when the page is first shown, security thing. Just say yes.
Well, I suppose your car is producing so much compression and HP that's it's shaking it's tail off. Replacing the tranny mounts is no biggy, just...
Of course in my case, it was a case of low compression in 2 cylinders on each bank, and now I find I need valve guides, which I'm doing now. I had...