Another BHCC 400i, anyone know this car?

Looks like a nice one... anyone have any ideas as to what the device beneath the glove box may be?

Ruben

 

Very nice! If this was right hand drive & in Australia I would have been very tempted. The extra trim on the sides is interesting.

 

Looks like a modern stereo. It says JVC on it.

 

When I worked at dealerships back in the 80's, we installed this type of "door guard" moldings. There are 2 styles, the first was attached with sticky back tape, the other style used pop rivets. We used 1/2 inch body shop tape to set a straight line, then cut the channel to the correct length, fastened it to the sheetmetal, then picked the proper end caps....we would cut the colored bump rubber from a roll just a bit longer, ( as it would shrink a bit in time ), and "roll" it into the channel.
For the new owners sake, I hope it's the adhesive type, and much easier to remove.

 

Funny speedometer label. Doesn't look anything like mine. Also, there is a huge vent looking thing on the console, passenger side in addition to the usual one.
I'll bet it sounds good with only the cat and just one muffler on each side.

 

Good day Daren.

Perhaps I have not had enough coffee this morning, but I do not see any cats on the car. I see the centre section muffler assembly has been replaced with what looks to me as glass packs (mini mufflers)... and the ends having the Ansa resonator/muffler. From what I have read on here, a lot of owners removed the centre section, etc and noted the improvement (sound and level) of the car's exhaust... and so I think you comment is on point.

Cheers,

Sam

 

We are looking at the same thing, and I'll bet you are correct with the glass packs rather than cats.

 

They also cut the collectors off the headers. Cleaner look but a shame too.

 

who else thinks the leather has been sprayed?
It will cost a lot to correct the exhaust and if those side moldings were stick on they'd probably have been already removed by now.
That said, I love the colors